- This topic has 1 reply, 2 voices, and was last updated 14 years, 11 months ago by
.
Viewing 2 posts - 1 through 2 (of 2 total)
- Posts
Just changed the master cylinder and brake lines on my Italkart. I have replaced the EVO1 master with the aftermarket master cylinder made for this specific replacement. I have run into a problem bleeding them. Not sure from where to bleed them due to the fact that when I attached the bleeder nothing happened. It seemed as if there was quite a bit of air in there but after trying to bleed for a while I was not getting much fluid out. Needless to say the brakes are non-functioning at the moment. Need some guidance on how to get them functioning properly. Gotta make the race next weekend. Thanks for the help,
Jordan
Viewing 2 posts - 1 through 2 (of 2 total)
- You must be logged in to reply to this topic.